1942 Series conductive adhesive
Product features
application:
kingbali 1942 Series conductive adhesive can be widely used in aviation, aerospace, ships and other military electronic equipment,but also can be used in communication equipment, electronic industry and other fields, canreplace the traditional sealing rubber, in order to complete the environmental seal andelectromagnetic seal.
Features and advantages:
▪ Two-component silica gel, ultra-low resistance, volume resistance ≤0.02 ohm.cm;
▪ Normal temperature curing, low shrinkage rate, to meet the requirements of precisionperiod, with good water resistance;
▪ The material has high stability and slow performance attenuation, which can meet therequirement of long-term use under the condition of thermal cycling.
EIGENVALUE
| characteristic | 1942 conductive adhesive | standard test |
| colour | Part A: Black / Part B: Gray | Visually |
| Viscosity | Component A: 80-150 Pa.S Component B: 60-120 Pa.S | ASTM D2196 |
| proportion | 2.45 g/cm3 | ASTM D792 |
| Flammability rating | V0 | UL 94 |
| Volume resistance | ≤0.02 Ohm-cm | ASTM-D257 |
| Tensile Strength | ≥0.8 MPa | ASTM D412 |
| Elongation at break | ≥100% | ASTM D412 |
| Tear strength | >6 N/mm | ASTM D624 |
| Minimum filling thickness | 0.1 mm | / |
| hardness | 50 Shore 00 | ASTM D2240 |
| Operating temperature | -40-180 ℃ | EN344 |
| Curing condition | ||
| Operating time (25°C) | 20 ～ 30 min | / |
| Curing time (25°C) | 20120 min | / |
| Curing time (60°C) | 20 ～ 25 min | / |
| Curing time (100°C) | 10 ～ 15 min | / |
| Note: The data recorded in this TDS are representative values rather than guaranteed values. To improve product performance, specifications are subject to change without notice. The use of the product recorded in this TDS is only an example. The product can have various application scenarios and environments, which are beyond our control. Therefore, you need to make your own sufficient before using the product to determine whether the product is suitable for your production process and conditions. Evaluate to confirm whether its performance and effect are in line with expectations. For applications that need to be considered safe, please test and confirm their safety in advance. In addition, the company does not guarantee that the use described in this TDS will not cause any patent infringement. Before using this product, please carefully read the explanatory text and safety data sheet (MSDS) marked on the main body of the product. This product is manufactured for general industrial applications. Do not use for medical purposes. The product may precipitate during storage. This is a normal phenomenon. Please mix well before use and strictly follow the product storage and transportation instructions. In order to obtain the best performance, the bonding surface should be clean, dry and free of grease. For high-strength structural bonds, special surface treatment can increase bond strength and durability. The material taken out of the container may be contaminated during use. Do not put the material back into the original container. Kingbali cannot be held responsible for products that are contaminated or stored under non-instructed conditions. | ||